A SERVICE OF

logo

Open as PDF
next previous
30 C
HAPTER
3: I
NSTALLING
AND
O
PERATING
THE
VCN A
CCESS
P
OINT
7
Insert two of the three short screws provided into the farthest indented
holes (Figure 19
) and drive them to the distance indicated in Figure 20.
Figure 19
Driving Two Screws into the Table
Figure 20
Offset of the Screw Head from the Table
8
Align the two large holes of the VCN AP (see Figure 21
) with the two
already driven screws.
9
Insert the screw heads into the holes and then shift the VCN AP forward
so that the screw shanks slip into the slots and the closest indented hole
is aligned with the VCN AP's small screw hole. See Figure 22
.
7/64 in
25 - 3mm
.
.