VCN Access Point Menus 55
The alternate state is Out of lock—the line to the VCN AC is not
connected.
■ Restarts, the number of times the line to the VCN AC undergoes a
cold restart. A cold restart occurs when there is a prolonged break in
the line.
■ Warm restart, a restart using information that existed the previous
time the link was operational. A warm start occurs when the line is
briefly disconnected or line noise occurs over a period of time.
■ SNR, signal to noise ratio.
AP Configuration
Menu
To configure the VCN AP, type
7 in the
Access Point Main Menu
and
press <Enter> ; the following options appear (Figure 50
):
Figure 50 The AP Configuration Menu
Set VLAN ID for Management
To set the VLAN ID perform the following steps:
1
In the
AP Configuration Menu
enter 1
.
2
Enter the VLAN ID number or enter
0 for none; a note appears as well as
a confirmation, as shown in Figure 51
.
AP Configuration Menu
----------------------
Current VLAN ID for Management: None
Current Ethernet mode: Half Duplex
1. Set VLAN ID for Management
2. Set Ethernet Half/Full Duplex Mode
3. Change Password
4. Reset to Factory Defaults
0. Return to Previous Menu
Please enter your choice: 0
