
462 CHAPTER 17: RF DETECTION COMMANDS
Examples — The following command configures MSS to ignore BSSID
aa:bb:cc:11:22:33 during RF scans:
WX1200# set rfdetect ignore aa:bb:cc:11:22:33
success: MAC aa:bb:cc:11:22:33 is now ignored.
See Also
■ “clear rfdetect ignore” on page 451
■ “display rfdetect ignore” on page 455
set rfdetect log Disables or reenables generation of log messages when rogues are
detected or when they disappear.
Syntax —
set rfdetect log {enable | disable}
■ enable — Enables logging of rogues.
■ disable — Disables logging of rogues.
Defaults — RF detection logging is enabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command is valid only on the seed switch of the Mobility
Domain.
The log messages for rogues are generated only on the seed and appear
only in the seed’s log message buffer. Use the display log buffer
command to display the messages in the seed switch’s log message
buffer.
Examples — The following command enables RF detection logging for
the Mobility Domain managed by this seed switch:
WX1200# set rfdetect log enable
success: rfdetect logging is enabled.
See Also
■ “display log buffer” on page 490