set radio-profile service-profile 293
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You must configure the service profile before you can map it to
a radio profile. You can map the same service profile to more than one
radio profile.
You must disable all radios that use a radio profile before you can change
parameters in the profile. Use the set radio-profile mode command
.
Examples — The following command maps service-profile wpa_clients
to radio profile rp2:
WX4400# set radio-profile rp2 service-profile wpa_clients
success: change accepted.
See Also
■ “display service-profile” on page 257
■ “set service-profile auth-dot1x” on page 295
■ “set service-profile auth-fallthru” on page 296
■ “set service-profile auth-psk” on page 298
■ “set service-profile beacon” on page 299
■ “set service-profile cipher-ccmp” on page 299
■ “set service-profile cipher-tkip” on page 300
wep key-index No keys
defined
Uses dynamic WEP rather than static WEP.
If you configure a WEP key for static WEP,
MSS continues to also support dynamic
WEP.
wep active-
multicast-index
1 Uses WEP key 1 for static WEP encryption
of multicast traffic if WEP encryption is
enabled and keys are defined.
wep active-unicast-
index
1 Uses WEP key 1 for static WEP encryption
of unicast traffic if WEP encryption is
enabled and keys are defined.
wpa-ie disable Does not use the WPA IE in transmitted
frames.
Table 58 Defaults for Service Profile Parameters (continued)
Parameter Default Value
Radio Behavior When Parameter Set
to Default Value
