display rfdetect visible 457
See Also
■ “display rfdetect data” on page 453
■ “display rfdetect visible” on page 457
display rfdetect
visible
Displays the BSSIDs discovered by a specific 3Com radio. The data
includes BSSIDs transmitted by other 3Com radios as well as by
third-party access points.
Syntax —
display rfdetect visible mac-addr
Syntax — display rfdetect visible ap map-num [radio {1 | 2}]
Syntax — display rfdetect visible dap
dap-num [radio {1 | 2}]
■ mac-addr — Base MAC address of the 3Com radio.
To display the base MAC address of a 3Com radio, use the
display {ap | dap} status command.
■ map-num — Port connected to the MAP access point for which to
display neighboring BSSIDs.
■ dap-num — Number of a Distributed MAP for which to display
neighboring BSSIDs.
■ radio 1 — Shows neighbor information for radio 1.
■ radio 2 — Shows neighbor information for radio 2. (This option does
not apply to single-radio models.)
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — If a 3Com radio is supporting more than one SSID, each of the
corresponding BSSIDs is listed separately.
To display rogue information for the entire Mobility Domain, use the
display rfdetect mobility-domain command on the seed switch.
