8
MOBILITY DOMAIN COMMANDS
Use Mobility Domain commands to configure and manage Mobility
Domain groups.
A Mobility Domain is a system of WX switches and MAP access points
working together to support a roaming user (client). One WX switch acts
as a seed switch, which maintains and distributes a list of IP addresses of
the domain members.
3Com recommends that you run the same MSS version on all the WX
switches in a Mobility Domain.
Commands by
Usage
This chapter presents Mobility Domain commands alphabetically. Use
Table 41 to locate commands in this chapter based on their use.
clear
mobility-domain
Clears all Mobility Domain configuration and information from a WX
switch, regardless of whether the WX switch is a seed or a member of a
Mobility Domain.
Table 41 Mobility Domain Commands by Usage
Type Command
Mobility Domain “set mobility-domain mode seed domain-name” on
page 228
“set mobility-domain member” on page 226
“set mobility-domain mode member seed-ip” on page 227
“display mobility-domain status” on page 225
“display mobility-domain config” on page 225
“clear mobility-domain member” on page 224
“clear mobility-domain” on page 223
