318 CHAPTER 10: STP COMMANDS
■ vlan vlan-id — VLAN name or number. MSS resets the cost for only
the specified VLAN.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — MSS does not change a port’s cost for VLANs other than the
one(s) you specify.
Examples — The following command resets the STP cost for port 2 in
VLAN sunflower:
WX4400# clear spantree portvlancost 2 vlan sunflower
success: change accepted.
See Also
■ “clear spantree portcost” on page 316
■ “display spantree” on page 320
■ “display spantree portvlancost” on page 325
■ “set spantree portcost” on page 336
■ “set spantree portvlancost” on page 338
clear spantree
portvlanpri
Resets to the default value the priority of a network port or ports for
selection as part of the path to the STP root bridge, on one VLAN or all
VLANs.
Syntax —
clear spantree portvlanpri port-list {all | vlan
vlan-id}
■ port-list — List of ports. The port priority is reset to 32 (the default)
on the specified ports.
■ all — Resets the priority for all VLANs.
■ vlan vlan-id — VLAN name or number. MSS resets the priority for
only the specified VLAN.
Defaults — None.
Access — Enabled.
