Filter
Top Products
See
Problem Cause Remedy
page
The picture is The video software is copy-protected.
disturbed.
No sound. Incorrect input or output cable Connect the cables properly. If the problem persists, 15
connections, the cables may be defective.
No appropriate input source has been Rotate the @INPUT selector (or press [_|nput 22
selected, selection key) to select the desired input source.
Speaker connections are not secure. Secure the connections. 11
The volume is turned clown or muted. Turn up the volume. 22
Signals this unit cannot reproduce are Display "Signal Int_" in the Option menu and check
being input from a source component, the input signal t_rmat.
such as a CD-ROM. lf"No Signal" is displayed, check if the playback
component is properly connected to this unit (or a
proper input source is selected).
If" " is displayed, the input signal in that format
cannot be reproduced by this unit.
The HDMI components connected to this Connect HDMI components that support the HDCP 81
unit do not support the HDCP copy copy protection standards.
protection standards.
"Audio Output" in "HDM]" is set to Set "Audio Output" (Function Setup -9 HDMI =-> 58
"TV". Audio Output) to the other setting.
A proper audio decoder is not selected. Display the Option menu and set "Decoder Mode" to 47
"Auto".
Only the center When a monaural source sound fiekt Try another sound field program. 25
speaker outputs program is applied, sound of all channels
substantial sound, are output from the center speaker for
some surround decoders.
The playback component or speakers are Connect the cables properly. If the problem persists, 12, 15
not connected properly, the cables may be defective.
No sound is output Output from that speaker is disabled. Check the Speaker indicators on the front panel 6, 22, 25,
from a specific display. If the corresponding indicator is turned oft', 55
speaker, try the t_llowing.
1) Change the input source to another one.
2) With the selected sound field program, sound is not
output from that speaker. Select another sound fiekt
program.
3) "None" may have been selected for that speaker on
this unit. Display "Speaker Setup" in the "Setup"
menu and enables output of that speaker.
Display "Speaker Setup" in the "Setup" menu and 57
adjust the volume (Manual Setup =->Speaker Level).
The volume of that speaker is set to
minimum in "Speaker Setup" in the
"Setup" nlenu.
This unit is in the straight decode mode.
Sound may not be output from certain
channels depending on input sources or
sound fiekt programs.
The speaker is malfunction.
Press (_STRAIGHT (or _STRAIGHT) to turn 28
off the straight decode mode.
Try another sound fiekt program. 25
Check the speaker indicators on the front panel
display. If the corresponding indicator lights up,
connect another speaker and check if sound is output.
If sound is not output, this unit may be malflmction.
67 En