Filter
Top Products
When the speakers are connected to EXTRA
SP terminals, press [_Cursor A repeatedly
to select "Extra Speaker Assignment" and
then press _]Cursor <1 / b> to select how to
use EXTRA SP terminals from "Zone2",
"Presence" or "None".
If this unit does not work when you press _]Cursor,
press [j_]ON SCREEN once and then operate this
unit.
To select sound characteristics for
adjustment, press [_Cursor _7to select "EQ
Type" and then press _]Cursor <1 It>.
If this unit does not work when you press [j_]Cursor,
press [j_]ON SCREEN once and then operate this
unit.
This unit has a parametric equalizer that adjusts the
output levels for each frequency range. The equalizer
is adjusted to produce a cohesive sound field based on
automatically measured speaker characteristics.
In "EQ Type", you can select the following
parametric equalizer characteristics suitable for the
desired sound characteristics.
Natural
This adjusts all speakers to achieve natural sound.
Select this if sounds in the high frequency range seem
too strong when "EQ Type" is set to "Flat".
Flat
This adjusts each speaker to obtain the same
characteristics. Select this if your speakers have
similar qualities.
Front
This adjusts each speaker to obtain the same
characteristics as the front left and right speakers.
Select this if your front left and right speakers have
significantly better qualities than the other speakers.
Press _]Cursor V to select "Start" and then
press _]ENTER to start the setup procedure.
A countdown starts and a measurement starts in 10
seconds. A loud test tone is output during
measurement.
When measurement is successfully completed,
"YPAO Complete" appears on the front panel display
and the measurement result appears on the GUI
screen.
Speaker Config
Displays the number of speakers connected to this unit in
the following order:
Total of Front and Center/Total of Surround and Surround
Back/Subwoofer
Distance (Min / Max)
Displays the speaker distance from the listening position
in the following order:
Closest speaker distance/Farthest speaker distance
Level (Min / Max)
Displays the speaker output levels in the following order:
Lowest speaker output level/Highest speaker output level
• lf"Error" appears on the GU1 screen during "Auto Setup", measurement
is canceled and the type of error is displayed. For details, see "When an
error message is displayed during measurement" (page 21).
• If problems occur during measurement, "Check xx warning(s)" (xx
indicates the number of warnings) appears in red. For details, see "When
a warning message is displayed after measurement" (page 21).
7
Press _]ENTER to confirm the settings.
The speaker characteristics are adjusted according to
measurement results.
To cancel the operation, press [j_]Cursor <:1/ t:> to
select "Cancel" and press _]ENTER.
When the following screen appears, remove the
optimizer microphone. "Auto Setup" is now
complete.
• During the automatic setup procedure, do not perli3rln any
operation on this unit.
• Press [_Cursor A to cancel the automatic setup procedure.
Measurement takes about 3 minutes. To obtain precise
results, stay where you will not disturb the
measurement, such as to the side of or behind the
speakers or outside the room.
The optimizer microphone is sensitive to heat. Store it
in a cool place and away from direct sunlight after
measurement. Do not leave it in a place where it will be
subjected to high temperatures such on an AV
component.
• lfyou do not want to apply the measurement results, select "Cancel".
• Perlorm "Auto Setup" again ifynu change the ]mmber or positions of
speakers.
• lfyou press I_ENTER belore removing the optimizer microphone,
"Auto Setup" of "Speaker Setup" in the Setup menu (page 55) is
displayed.
20 En