Filter
Top Products
Although the field sound programs would satisfy you as
they are with the default parameters, you can arrange
sound effect or decoders suitable for acoustical conditions
of sources or rooms by setting the parameters.
-4'--
• You cannot configure the parameters when "Memory Guard" is set to
"On" (page 6(t).
1 Turn on the video monitor connected to this
unit.
2 Press I_ON SCREEN on the remote control.
The GUI screen appears on the video monitor.
3 Press []Cursor V to select "Setup" and then
press []ENTER.
4 Press []Cursor A / V to select "DSP
Parameter" and then press []ENTER.
Sound field program
?_t I
• The defimlt settings are marked with '"::"
CINEMA DSP basic parameters
DSP Level
Adjustable range: 6dB to 0dB* to +3dB
Fine adjusts fineffect level (level of the sound field effect
to be added). You can adjust the level of the sound field
effect while checking sound levels. Adjust "DSP Level" as
follows.
* The effect sound is too soft.
* There are no differences between effects of the sound
field programs.
--+Increase the effect level.
° The sound is dull.
° The sound field effect is added too much.
--+Reduce the effect level.
Dialogue Lift
Choices: 0* to 5
Use this feature to adjust the vertical position of the
dialogues in movies. The ideal position of the dialogues is
at the center of the video monitor screen.
Sound fiei parameters Set' _lues
Press []Cursor A/ V to select "Program
Name" and then press []Cursor <1 / I;> to
select a sound field program to edit.
Press []Cursor A/ V to select a parameter to
edit and then press []Cursor <1 / I;> to
change the setting.
For details on functkms find adjustable ranges of the
sound field parameters, see "Sound field parameters"
on this page.
-4'--
• Repeat steps 5 and 6 to change other sound field program
parameters.
7 To turn off the GUI screen, press I_ON
SCREEN.
To initialize the parameters of the selected sound field
program, press [Cursor V repeatedly to select
"Initialize" and then press [Cursor t:>. Then, press
[Cursor t:> again to execute the initialization or
[Cursor <:1to cancel it.
ideal dialogue
position
If the dialogues are heard at the lower position of the video
monitor screen, increase the value of "Dialogue Lift".
Move upto the ideal
dialogue position
When the value is set to zero, the position is at the lowest.
The position gets higher as you increase the value.
• This setting is available only when "Extra Speaker Assignment" is set to
"Presence" (page 56).
• You cannot move the dialogue position down from the initial dialogue
position.
3D DSP
Choices: On*, Off
When CINEMA DSP 3D is enabled, sets whether to use
sound field programs in 3D mode.
50 En