Filter
Top Products
If an error is detected during measurement, the
measurement is canceled and "Error" appears on the GUI
screen. Check the error and solve the problem. For details
on each error message, see page 75.
Press _Cursor V once, press _Cursor <1 / t:>
to select "Retry" or "Exit" and then press
[]ENTER,
Retry
Performs "AutoSetup" again.
Exit
Terminates the measurement and "Auto Setup".
--'4'--
• When "E-5:NO1SY" appears, you can continue measurement. To
continue measurement, select "Prnceed". However, we recommend that
you solve the problem first and then perlorm measurement again.
If a problem occurs during measurement, "Check xx
warning(s)" appears on the GUI screen. Check the
warning and solve the problem. For details on each
warning message, see page 76.
• Optimization will not be performed while a warning message is
displayed. We recommend that you solve the problem and perform "Auto
Setup" again.
Press []Cursor V / A to select "Check xx
warning(s)" and then press []ENTER.
Details of the warning message are disphtyed. If there
are multiple warning messages, you can display the
next message using [Cursor t:>.
2 To returnto the top result display, press
[ENTER again.
21 En