Filter
Top Products
58
SYSTEM OPTIONS
• The available parameters may be displayed on more than one
page of the on-screen display. To scroll through pages, press
k/n.
• You cannot change parameter values when Memory Guard is
set to “Guard”. If you want to change the parameter values, set
Memory Guard to “Free” (see page 78).
Use this feature to reassign digital input/outputs, select the
input signal, rename the inputs, or adjust the level of the
signal input to each jack.
1 Press TOP on the GUI remote control.
2 Select Input Select, then press h.
3 Select the desired input (CD, DVD, etc.), then
press h to access and adjust.
■ Mode (Mode)
Use this feature to select the input signal.
Input Select > input source (DVD, etc.) > Mode
Choices: Auto, D.D.RF, DTS, Digital, i.LINK, Analog
y
• This menu is only available for input sources that have been
assigned digital jacks.
• Before you can select i.LINK, you must first connect this unit to
an i.LINK component and assign it to an input.
• Before you can select D.D.RF, you must first select DTV/LD as
the input source and then specify 1 LD-RF for the Coaxial
Input (see page 59).
Notes
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more
than one week, the parameter values will return to the
factory settings. If this happens, edit the parameter
value again.
Input Select
00EN.00_DSPZ9_GB.book Page 58 Thursday, November 13, 2003 10:55 AM