Filter
Top Products
34
AUTO SETUP
You can confirm the results of each analysis.
If you set Setup Type to Auto.
The results are displayed after all items have been
analysed.
•Press n and select Setup to set the measured values.
•Press k and select Retry to retry the auto setup procedure.
•Press h and select Detail to view information about
measurement results and error or warning messages. For
more details about error and warning messages, see
“Troubleshooting for the auto setup procedure” on
page 35.
•Press l and select Exit to cancel the auto setup procedure.
If you set Setup Type to Step.
The results are displayed individually after each analysis.
• Press n and select Next to start measurement of the next
menu item.
• Press k and select Retry to measure the current item again.
• Press h and select Detail to view information about
measurement results and error or warning messages. For
more details about error and warning messages, see
“Troubleshooting for the auto setup procedure” on
page 35.
• Press l and select Exit to cancel the auto setup procedure.
After all menu items have been measured, “Measurement
Over” appears on the screen and the results for each item
are displayed.
• Press n and select Setup to set the measured values.
• Press k and select Retry to retry the auto setup procedure.
• Press h and select Detail to view information about
measurement results and error or warning messages. For
more details about error and warning messages, see
“Troubleshooting for the auto setup procedure” on
page 35.
• Press l and select Exit to cancel the auto setup procedure.
y
If you want to make more detailed settings, change the system
parameters using the Manual Setup menu. If you want to return to
the Auto Setup settings after making settings in the Manual Setup
menu, navigate to the Information screen in the Auto Setup menu,
press k/n repeatedly to select the parameter you want to adjust,
then press ENTER.
• If you change speakers, speaker positions, or the layout of your
listening environment, perform auto setup again to re-calibrate
your system.
• In the Distance results, the distance displayed may be longer
than the actual distance depending on the characteristics of your
subwoofer. This may also be the case when using an external
amplifier.
• In the Equalizing results, different values may be set for the
same band to provide finer adjustments.
Confirming the results
Notes
00EN.00_DSPZ9_GB.book Page 34 Thursday, November 13, 2003 10:55 AM