ISM4 INSTALLATION & PROGRAMMING MANUAL
32
NEXT Not used in this IR Learn Mode.
PREV If not save of any learned IR is desired, press to return to Edit Mode.
Delay Program Mode
Press the Front Panel Buttons and observe the LED’s to program Delays in Command Structures as follows:
NOTE: Upon entering Delay Edit Mode, the Delay Value is reset to 0 seconds.
Figure 12 Front Panel Navigation – Delay Program Mode
DELAY Not used in this Delay Program Mode.
NEXT In Delay Program Mode each press will increase the amount of delay by one second from 0-60
seconds. After 60 seconds a press of the Next Button will set the delay to 0 seconds.
PREV In Delay Program Mode each press will decrease the amount of delay by one second from 0 to
60 and down to 0 second. After 0 seconds a press of the Prev Button will set the delay to 60
seconds.
TEST After a delay duration has been selected, but not saved, a press of the Test Button will initiate the
delay. The currently selected Source LED will flash the number of times equal to the duration of
the delay.
DELETE Press to remove delay value in the currently selected Command Structure.
SEQUENCE Press to save a delay to a Command Structure. This action will automatically exit IR Learn Mode
and enter Edit Mode. Recall that full navigation on a Command Structure and Macro level is
permissible in Edit Mode.