Filter
Top Products
Characters
This setting allows the RF Terminal to output chosen ASCII characters in place of the actual characters
entered. For example, if you scanned the number 1 (hex 31) and wanted the RF Terminal to output hex 92
instead, you would enter 3192 for the Characters parameter. This would re-assign the output characters,
with the RF Terminal outputting hex 92 every time it sees hex 31. To re-assign characters:
• Select option “8” from the RF Terminal Setup menu then “3” to enable character entry. A square cursor
will appear.
• Enter up to seven 4-digit pairings where the first 2 digits represent the hex number to replace and the second
2 digits represent the hex number to insert. You can have up to seven character reassignments.
• Press “Enter” when done or “Clear” to reset to none.
You can eliminate the output of a character by using FF as the hex number to insert. For example, if you
wanted to eliminate all $, following the above instructions, enter 24FF.
System Tools
Download File
This will allow you to download a new voice prompt file or a firmware update. You must run the utility
program on the PC to download the file.
Play Voice Prompt
To play a voice prompt, select option “2” then enter the 2-digit number of the voice prompt that you wish to
play. The valid range is 01 to 99.
Reset to Factory Default
Select option “3” to reset all setup values to the factory default values. This will reset all values in all
menus of the RF TERMINAL SETUP.