Filter
Top Products
Speaker Settings
Speaker Options
Beep Volume
OFF 1
Low 1
Medium 1
High 1
The default volume of the “Beep” is Medium. Each time you press the “1” key you will hear a
beep at the different volume settings. When you are happy with the loudness of the beep tone, press 0
or F1 to exit.
Beep Tone
1 - Lowest 2
2 - Low 2
3 - Medium 2
4 - High 2
5 - Highest 2
The default beep tone is 3 – Medium. Each time you press the “2” key you will hear a beep at
various tones. When you are happy with the tone of the beep, press 0 or F1 to exit.
Voice Volume
OFF 3
Low 3
Medium 3
High 3
The default volume of the “Voice” is Medium. Unless you need very loud voice prompts you should
use the medium setting to conserve battery power. When you are happy with the loudness of the
beep tone, press 0 or F1 to exit.
Keypad Tone
Keypad Tone ON OFF 4
The “Keypad Tone” is the key click that you hear each time a key is pressed. Press the “4” key to
toggle this On and Off.
Laser Options
Double Decode
Double Decode ON OFF 1
• Double Decode is there to minimize the possibility of misreads when scanning very poor quality bar codes.
This option forces the RF Terminal to keep reading until it gets two results that are identical. This "double
scan checking" takes longer but will minimize misreads since it must get the same result twice before
considering it a "good" read.
4.5 Second Laser Beam
4.5 Second Laser Beam ON OFF 2
• 4.5-second laser beam increases the amount of time the laser beam is activated, giving the laser more time