Filter
Top Products
12
Connecting Speakers
The Speaker Terminals are located on the rear panel. There
are two FRONT terminals, one CENTER terminal, Two SUR-
ROUND terminals and two SURR BACK (surround back)
terminals. Be sure to connect the left channel (L), right
channel (R), “+” (red) and “--” (black) properly.
Caution
•
I
f using 4
Ω
speak
ers, be sure to set the DTX-
99
09K’s speaker impedance
setting to
4
Ω
before
using. If
using 8
Ω
speakers, make sure it is set to
8
Ω
. The speaker impedance switch is
located on
the rea
r panel.
• Before connecting the speakers, make sure that the DTX-
9909K is disconnected from the power source.
• Do not let the bare speaker wires touch each other or
another metal part of this unit. This could damage the
DTX-9909K and/or the speakers.
Preparing the Speaker Cable
You can either used an exposed speaker wire or Banana
Plug speaker cable.
Exposed
Speaker W
ire
1. Remove approximately 3/8” (10mm) of insulation
2. Twist the exposed wires together to prevent short circuits
3. Loosen the knob on the speaker terminal
4. Insert the bare wire
5. Tighten the knob until the wire is secure
Getting Connected