Filter
Top Products
93
Search and Close Call Options
will skip the frequency when Data Skip is on. Turn the
feature off or talk into the transmitter.
• The default for this feature is On.
Setting the Delay Time
Srch/CloCall Opt E
Set Delay Time E
This setting determines how long the scanner waits after
a transmission ends before resuming quick search or
Close Call operation. Select your setting, then press E.
Off The scanner resumes immediately when the
transmission ends.
1-5 sec The scanner waits the set amount of time after
the transmission ends before resuming.
Note: The default setting is 2 seconds.
Setting the Search Frequency Step
Srch/CloCall Opt E
Set Step E
This setting selects the frequency step used for setting
the channels. Select your setting, then press E.
Auto The step is based on the band (see the table at the
front of the manual)
5.0 kHz, 6.25 kHz, 7.5 kHz, 10.0 kHz, 12.5 kHz, 15.0 kHz,
20.0 kHz, 25.0 kHz, 50.0 kHz, 100.0 kHz The scanner
uses the selected step.
Note: The scanner defaults to Auto.
Menu
Menu