Filter
Top Products
60
Programming Radio Systems
When the scanner prompts Confirm?, press E to accept
the settings. The scanner creates an empty LTR system,
with a default name of System nnN L.
nNn increments as you add new systems. L indicates that
this is an LTR system.
Next, refer to the appropriate section to set system-wide
options. For most settings, you can accept the default.
However, for the items in bold, you must enter informa
-
tion in order for your scanner to scan the system.
•See “Editing the System Name” on Page 62
•See “Setting the System Hold Time” on Page 63
•See “Editing the System Quick Key” on Page 62
•See “Setting the Channel Delay Time” on Page 64
•See “Setting ID Scan/Search (Trunked Systems
Only)” on Page 64
•See “Reviewing Locked Out Frequencies” on Page 89
•See “Setting Channel Attenuation (Conventional
Channels Only)” on Page 76
•See “Deleting Systems” on Page 70
•See “Copying Systems” on Page 70
•See “Setting System Frequencies” on Page 60
•See “Entering/Editing LTR Channel Groups” on
Page 60
Setting System Frequencies
SET FREQUENCIES E
New FREQUENCY E
Input a system frequency, then press E. The scanner then
prompts you to enter the LCN for the entered frequency.
Enter the LCN, then press E.
To enter additional frequencies, press , use the scroll
control to select New Frequency, then repeat the above.
Entering/Editing LTR Channel Groups
To enter channels in a system, first set up a channel
group (or groups) to hold the channels. Then, enter the
channel and channel parameters in the group(s).
Menu