Filter
Top Products
77
Programming/Editing Optional Settings
On - the channel is attenuated by about 18 dB.
Off - the channel is not attenuated.
Notes:
• The default setting is Off.
• For trunked systems, the attenuation is a system-
level setting.
• You can also toggle this setting by holding on the
channel and pressing
and E.
Setting the Frequency Step
(Conventional Channels Only)
program system E
Select the system E
Edit Group E
Select the group E
Edit Channel E
Select the channel E
Set Step E
This setting selects the frequency step used for setting
the channel's. Select your setting, then press E.
Auto - the step is based on the band (see the table at the
front of the manual)
5.0 kHz, 6.25 kHz, 7.5 kHz, 10.0 kHz, 12.5 kHz, 15.0 kHz,
20.0 kHz, 25.0 kHz, 50.0 kHz, 100.0 kHz - The scanner
uses the selected step.
Note: The scanner defaults to Auto.
Setting Channel Lockout
program system E
Select the system E
Edit Group E
Select the group E
Edit Channel E
Func
Menu
Menu