Filter
Top Products
76
Programming/Editing Optional Settings
Setting Channel Modulation
(Conventional Channels Only)
program system E
Select the system E
Edit Group E
Select the group E
Edit Channel E
Select the channel E
Set Modulation E
This setting controls the demodulation method used for
the channel. Select your setting, then press E.
Auto - the scanner uses the default modulation for the
frequency (see the table at the front of the manual).
AM - the scanner uses AM (amplitude modulation) for the
frequency.
FM - the scanner uses FM (frequency modulation) for the
frequency.
NFM - the scanner uses narrowband FM for the
frequency.
Note: The default setting is AUTO.
Setting Channel Attenuation
(Conventional Channels Only)
program system E
Select the system E
Edit Group E
Select the group E
Edit Channel E
Select the channel E
Set Attenuator E
This setting controls whether the scanner attenuates
signals on this channel. Select your setting, then press E.
Menu
Menu