Uniden BC246T Radio User Manual


 
100
Troubleshooting
If you still cannot get satisfactory results while using your
scanner or if you want additional information, please call
or write the Uniden Parts and Service Division. The
address and phone number are listed in the Warranty at
the end of this manual. If you would like immediate assis
-
tance, please call Customer Service at (800) 297-1023.
If you have Internet access, you can visit
http://www.uniden.com for additional information.
Scanner won’t
stop scanning
a trunked
system.
No ID’s have been
programmed.
Program one or more
ID’s or use the ID
Search mode.
The ID’s you have
stored are not
active.
Wait for the ID’s to
become active or
scan another system.
Scanner won’t
acquire the
data channel.
The squelch might
need to be
adjusted.
Adjust the squelch
threshold. See
“Turning On the
Scanner and Setting
the Squelch” on
Page 40.
The frequency
used for the data
channel might be
missing.
Check your
frequency list for the
data channel.
Missing replies
to
conversations.
The scanner might
need to be
changed to a Type
1 scanner setup.
Change to a Type 1
scanner setup. See
“Programming
Motorola Systems”
on Page 53.
The fleet map
might be incorrect.
Try another preset
fleet map or program
your own fleet map.
One or more of
the system’s
frequencies might
not be entered.
Make sure all the
system’s frequencies
have been entered.
The system you
are trying to scan
might be LTR or
EDACS.
Set the scanner to
scan LTR or EDACS
systems. Review
“Programming LTR
Systems” on Page 59
and “Programming
EDACS Systems” on
Page 57.