Filter
Top Products
57
Programming Radio Systems
To program another channel within the same group, press
, then repeat the above.
To create another channel group and enter more
channels, press three times, then proceed from
“Entering/Editing Motorola Channel Groups” on Page 55.
Programming EDACS Systems
Program SysteM E
New System E EDCS E
Next, rotate the scroll control to select the type of EDACS
system you will program, then press E.
• WIDE - Use for wideband EDACS systems
• NARROW - Use for narrowband EDACS systems
• SCAT - Use for EDACS SCAT (Single Channel
Autonomous Trunking)
When the scanner prompts Confirm?, press E to accept
the settings. The scanner creates an empty EDACS
system, with a default name of System nnN E.
nnN increments as you add new systems. The E indicates
that this is an EDACS system.
Next, refer to the appropriate section to set system-wide
options. For most settings, you can accept the default.
However, for the items in bold, you must enter
information in order for your scanner to scan the system.
•See “Editing the System Name” on Page 62
•See “Editing the System Quick Key” on Page 62
•See “Setting System Lockout” on Page 63
•See “Setting the System Hold Time” on Page 63
•See “Setting the Channel Delay Time” on Page 64
•See “Setting ID Scan/Search (Trunked Systems
Only)” on Page 64
•See “Setting I-Call (Motorola and EDACS Systems
Only)” on Page 68
Menu
Menu
Menu