54
Programming Radio Systems
• 800MHz Standard - Use for 800 MHz systems that
use the standard band plan
• 800MHz Splinter - Use for 800 MHz systems that use
the splinter band plan (typically near international
borders)
• 900MHz Band - Use for 900 MHz systems
• VHF Band - Use for VHF systems
• UHF Band - Use for UHF systems
Next, refer to the appropriate section to set system-wide
options. For most settings, you can accept the default.
However, for the items in bold, you must enter
information in order for your scanner to scan the system.
•See “Editing the System Name” on Page 62
•See “Editing the System Quick Key” on Page 62
•See “Setting System Lockout” on Page 63
•See “Setting the System Hold Time” on Page 63
•See “Setting the Channel Delay Time” on Page 64
•See “Setting ID Scan/Search (Trunked Systems
Only)” on Page 64
•See “Setting the Base Frequency/Step/Offset (Motor-
ola UHF/VHF Systems Only)” on Page 65 (must be
set up for VHF or UHF systems)
•See “Editing the Fleet Map (Motorola Systems Only)”
on Page 66 (must be set up for Type I systems)
•See“Setting the Motorola Status Bit (Motorola Sys-
tems Only)” on Page 67
•See “Setting the End Code Operation (Motorola Sys-
tems Only)” on Page 67
•See “Setting I-Call (Motorola and EDACS Systems
Only)” on Page 68
•See “Setting Emergency Alert (Motorola and EDACS
Systems Only)” on Page 68
•See “Setting Control-Channel Only (Motorola Sys-
tems Only)” on Page 69
•See “Setting System Lockout” on Page 63