Filter
Top Products
57
Auxiliary YUV sockets
If your video monitor features a YUV input, you should
connect the monitor and all YUV-capable source devices
using YUV cables in addition to the Video or S-Video
wiring. You can then switch your monitor to YUV mode
when using these sources, and in this way obtain the
absolute best possible picture quality when watching a
film. The YUV module of your
DD 1535 R
features a
signal bandwidth of 350 MHz, is absolutely loss-free, and
is therefore prepared for future high-resolution video
standards (HDTV).
When installing a device, a YUV input of the
DD 1535 R
must be assigned to each YUV source device connected
to the system (see
'
Wiring Diagram 4
'
and the chapter
'
Configuration / YUV Inputs
'
).
Note:
Even if you own YUV-capable source devices, you still
need to connect standard Video or S-Video cables, as
these signals are essential for video recordings
Recording with the DD 1535 R
Picture norms
To make recordings using a video recorder the source
device from which the recording is to be made must be
connected to the
DD 1535 R
using either a Video or S-
Video lead. It is not possible to make recordings from
source devices which are connected solely using a
Component input, as video recorders are not designed to
handle Component signals.
Selecting the recording source
To select the source device from which the recording is
to be made, press the
button under the front flap
of the
DD 1535 R
. While you hold the
button
pressed in, you can select the source device you wish to
use by means of the source buttons.