Filter
Top Products
35
Installation, using the unit for the first time
General notes on setting up the unit:
Carefully unpack the digital surround decoder and store
the original packing materials carefully. The carton and
packing are specially designed for this unit and will be
needed again if you wish to move the equipment at any
time. Please be sure to read the safety notes in these
instructions.
If the unit gets very cold (e. g. when being transported),
condensation may form inside it. Please do not switch it
on until it has had plenty of time to warm up to room
temperature, so that any condensation evaporates
completely.
Before placing the unit on a sensitive surface, please
check the compatibility of the lacquer and the unit’s feet
at a non-visible point.
The decoder should be placed on a rigid, level base.
When placing the unit on resonance absorbers or de-
coupling components make sure that they do not
compromise the stability of the unit.
The unit should be set up in a dry, well-ventilated site,
out of direct sunlight and away from radiators.
The unit must not be located close to heat-producing
objects or devices, or anything which is heat-sensitive or
highly inflammable.
When installing the unit on a shelf or in a cupboard it is
essential to provide an adequate flow of cooling air, to
ensure that the heat produced by the unit is dissipated
effectively.
Any heat build-up will shorten the life of the unit and
could be a source of danger!
Note:
• The
DD 1535 R
is designed exclusively for use in
conjunction with a
R
-series stereo pre-amplifier,
integrated amplifier or receiver.
• The
DD 1535 R
features five integral output stages for
the Centre, Surround and Rear loudspeakers. The
signals for the front speakers are reproduced by the
output stages of the stereo amplifier.
• The
DD 1535 R
is remotely controlled via the
R
LINK
system and the stereo unit.
• For possible combinations with external devices or
amplifiers without
R
LINK
, please contact your
dealer.