Filter
Top Products
16
Configuration
You can call up the 'Configuration' menu by pressing
the remote control button
or
, or the
button on the front panel of the decoder; in
either case hold the button pressed in for about two
seconds.
Display brightness:
The brightness of the screen can be set to suit your
personal preference. Three brightness levels are
available:
off the screen is completely switched off.
soft subdued setting, for dark locations.
normal clearly legible, even in sunlight.
If you set brightness level 'off', the screen switches
briefly to normal brightness every time you give a
command, so that you can check the settings easily even
from a distance. After about four seconds the screen
automatically switches back to your preferred brightness
level. If you change the brightness level, this also means
that the new value only becomes effective after about
four seconds.
Switching the on-screen main menu on
and off:
If you just wish to make a temporary change to the
balance or tone, it is not absolutely necessary to call up
the 'Main Menu' on the television screen and
superimpose it on what you are watching; in most cases
the display on the decoder’s screen is quite adequate. At
this menu point you can switch the TV on-screen main
menu display on and off.
off The 'Main Menu' appears line by line on the
decoder’s screen, but not on the TV screen.
on The 'Main Menu' appears on the TV screen
and also line by line on the decoder’s
screen.
On-screen language:
The on-screen menus can be displayed on the TV
screen in different languages. Here you can select your
language.
Loudspeaker:
The 'Loudspeaker Menu' provides the means to
balance the output signals to the loudspeakers in your
surround system. At the same time you can adjust the
output of the speakers accurately to suit the acoustic and
spatial characteristics of your listening room.
Video inputs:
In the 'Video inputs Menu' you can set the correct
picture norm to match the picture sources connected to
all the decoder’s video inputs and outputs.
YUV inputs:
Many source devices feature a high-quality Component
(YUV) picture output. If you wish to use this, the source
device must be assigned to the YUV input of the
DD 1535 R in the 'YUV Inputs menu'.
Audio inputs:
The ‘Sound Inputs Menu’ is used to integrate the AV
sources connected to the decoder in the overall control
system of an 'R'-system. This is achieved by first
assigning a name to each AV source device connected
to the decoder; it will then appear under this name on the
decoder’s integral screen. You can then select the Audio
/ Video input socket(s) to which it is connected. Finally
a source button on the remote control handset can be
assigned to each AV source, which is then used to select
it in surround mode.
Special functions:
Menu for assigning the high-quality Component Video
picture inputs (YUV) to the source devices.