Filter
Top Products
37
Connecting the TV set and surround speakers to the decoder:
For important information regarding loudspeaker
configurations and modes of operation please refer to
the chapter
'
Loudspeaker configurations for the
DD 1535 R
'
.
The components of your system should be connected as
shown in Wiring Diagram
1
. This is the procedure:
• Connect the surround loudspeakers to the
appropriate output terminals on the decoder.
• If present, connect the input of the active sub-woofer
to
SUB OUT
.
• Connect the monitor socket on the decoder to your
TV set using a video cable.
Note:
If your TV set has a SCART input socket, please use
the S-Video / SCART adaptor lead supplied.
• Connect the aerial input
FM ANT
to a FM aerial
socket.
To check the connection between your TV set and the
DD 1535 R
switch your television to the external AV input
and temporarily call up the
'
Configuration menu
'
.
This is done by holding the
button on the front
panel of the
DD 1535 R
or the
F6
pressed in.
• This is done by holding the
button on the
front panel of the
DD 1535 R
pressed in.
If this menu does not appear, the screen shows
monochrome picture or the picture is unstable, please
read the section
'Trouble-shooting'
.