Filter
Top Products
38
Connecting the decoder to a
integrated amplifier
with TASI and R
LINK
socket:
To keep the wiring diagram as clear as possible, only the
integrated amplifier is shown, i. e. not the analogue
source devices. The source devices should be
connected as shown in following wiring diagrams.
Complete the wiring of the components as shown in
wiring diagram as follows:
• Connect the
TASI
interface on the decoder to the
TASI
socket on the pre-amplifier or integrated
amplifier using the
TASI
lead.
• Connect the
R
LINK
socket on the decoder to the
R
LINK
socket on the integrated amplifier.
• Please be sure to connect the pre-amplifier output
PRE
on the pre-amplifier to the sub-woofer input
SUB
IN
on the decoder. This improves the signal : noise
ratio of the system, even if the sub-woofer is not used
in standard stereo mode.
Note:
If you are using a pre-amplifier with only one
PRE
output, and you have already connected the power
amplifier to this, you can use a
Cinch Y-lead
adaptor
to gain access to the pre-amplifier signal. Please ask
your specialist dealer for advice.
• Finally connect the mains power supply and switch
the system on.