Filter
Top Products
46
GB
E:\STR-DA7100ES\2320745143\2320745143STRDA7100ESUC\01GB-
STRDA7100ESUC\030CON.fm
masterpage: Left
STR-DA7100ES
2-320-745-14 (3)
If the command modes of the receiver and the
remote are different, you cannot use the remote to
operate the receiver.
If the command modes of both this receiver and the
remote are the initial setting, it is not necessary to
reset up them.
You can switch the command mode (AV
SYSTEM 1 or AV SYSTEM 2) of the receiver
and the remote. If the command mode of the
receiver and the remote is different, you cannot
use the remote to operate the receiver.
To set up the remote for the
receiver
1 Press RM SET UP.
The set up list appears.
2 Move the easy scroll key to
select “COMMAND MODE,”
then press the key to enter the
selection.
The COMMAND MODE list appears.
3 To select the command mode
for the main receiver
Move the easy scroll key to select
“MAIN,” then press the key to enter the
selection. The MAIN list appears.
Move the easy scroll key to select “AV
SYSTEM 1” or “AV SYSTEM 2,” then
press the key to enter the selection.
Tip
The COMMAND MODE appears in the first line of
the display only when the remote is turned on by
pressing SOUND FIELD or INPUT SELECTOR.
To set the remote for the
receiver on the receiver
Turn on the receiver while pressing
2CH.
“COMMAND MODE [AV2]” appears on the
display. Check that the command mode is set
to AV SYSTEM2.
If you repeat the same operation again, the
setting will change to AV SYSTEM1 from AV
SYSTEM2.
When the Sony equipments are
operated by remote of the
receiver
Change the setting of the receiver and remote
to AV SYSTEM1.
About the command mode
Switching the COMMAND MODE
1
2