Filter
Top Products
34
GB
E:\STR-DA7100ES\2320745143\2320745143STRDA7100ESUC\01GB-
STRDA7100ESUC\030CON.fm
masterpage: Left
STR-DA7100ES
2-320-745-14 (3)
Notes on converting video signals
• You can convert only the 480i of component
video signals into HDMI signals, S-VIDEO
signals, or VIDEO signals. Signals are
converted from 480i interlace scanning to
480p progressive scanning, then the signals
are output.
• When video or S-video signals from a VCR,
etc., are converted on this receiver and then
output to your TV, depending on the status of
the video signal output, the image on the TV
screen may appear distorted horizontally or
no image may be output.
• An HDMI video signal cannot be converted
to a component signal, an S-video signals
and video signal.
• REC OUT does not have an up convertion
function.
• S2 information (aspect information for the
images) included in S-video signals is
effective only when S-video input signals
are output from the S-video MONITOR
OUT jack. An aspect ratio of images may
not be displayed correctly when video
signals and component video signals are
converted and are output from the S-video
MONITOR OUT jack.
• (Models of area code CEL only)
SECAM video signals are converted to PAL
signals and output when VIDEO CONVERT
is “ON.” Set VIDEO CONVERT to “OFF,”
when you output signals in SECAM system.
Closed Caption display
• Set VIDEO CONVERT to “OFF” when
receiving a signal that supports Closed
Captions. If VIDEO CONVERT is set to
“ON,” you cannot display Closed Captions.
• Only component video input signals of 480i
are accepted when “PROGRESSIVE OUT”
is set to “ON.”
Assigning video input signals
to other input
Component video input signals and HDMI
input signals can be assigned to other input
(page 63, 64, 70).