Filter
Top Products
24
Erasing phrases
On the recorder
1 While the recorder is stopped, press the
jog dial.
2 Turn the dial until “EDIT” appears, and
then press to enter.
3 Turn the jog dial until “BankErase”
appears, and then press to enter.
4 Turn the jog dial until the phrase you
want to erase flashes in the display, and
then press to enter.
“Erase!” appears and the phrase is
erased.
On the remote control
1 While the recorder is stopped, press
DISPLAY for 2 seconds or more.
2 Turn the control repeatedly until
“EDIT” flashes in the display, and press
x to enter.
3 Turn the control repeatedly until
“BankErase” appears in the display, and
then press x to enter.
4 Turn the control repeatedly until the
phrase you want to erase appears, and
then press x to enter.
To cancel the operation
Press CANCEL on the recorder.
Press DISPLAY for 2 seconds or more on the
remote control.
Registering tracks or
groups as a new group
(Group Setting)
See the illustrations in English text (page 54).
Do the following procedure to register tracks or
groups as a new group. The tracks or groups
must, however, be sequential. If the desired
tracks or groups are not consecutive, you must
move them to make them consecutive before
you can register them (“Moving recorded
tracks”, page 25). The operation of this function
depends on whether group mode is on or off.
• When group mode is ON:
Several groups are registered as one group.
A track without group setting can be
registered to an existing group.
• When group mode is OFF:
Several tracks are registered as one group.
The following section explains the operation
when group mode is on.
On the recorder
1 Press GROUP for 2 seconds or more to
turn the group mode on.
2 While the recorder is stopped, press the
jog dial.
3 Turn the jog dial until “EDIT” flashes in
the display, and then press to enter.
4 Turn the jog dial until “ : Set”
flashes in the display, and then press to
enter.
5 Turn the jog dial until the number or
name of the desired first track flashes in
the display, and then press to enter.
This selects the first track of the new
group.
Even when the group mode is on, track
numbers appear according to their order
on the disc, not their order within the
group.
6 Turn the jog dial until the number or
name of the desired last track flashes in
the display, and then press to enter.
This selects the last track of the new
group.
7 Follow steps 4 to 8 of “Labeling
recordings” (page 19) to label a group.
On the remote control
1 Follow the procedure of “To activate the
group mode” (page 10) to turn the group
mode on.
2 While the recorder is stopped, press
DISPLAY for 2 seconds or more.
3 Turn the control repeatedly until
“EDIT” flashes in the display, and then
press x to enter.
4 Turn the control repeatedly until
“GP:Set” flashes in the display, and then
press x to enter.