Filter
Top Products
21
Relabeling recordings
On the recorder
1 Insert a disc and do the following.
To relabel a track:
Start playing a track you want to relabel,
and change a track name while the
recorder is playing.
To relabel a group:
Turn the group mode on (page 14) and
start playing or recording a track within
the group you want to relabel, and
change the group name while the
recorder is playing or recording.
To relabel a disc:
Relabel the disc while the recorder is
stopped or recording.
If you relabel a disc with group settings,
turn the group mode on (page 14).
2 Follow steps 2 to 4 of “Labeling
recordings” (page 19) to display a track,
group, or disc name.
3 Follow steps 5 to 8 of “Labeling
recordings” (page 19), and then keep
pressing the jog dial for 2 seconds or
more.
On the remote control
1 Insert a disc and do the following.
See step 1 of “On the recorder”to check
the varieties of name you can relabel.
2 Follow steps 2 to 4 of “On the remote
control” (page 20) in “Labeling
recordings” to display a track, group, or
disc name.
3 Follow steps 5 to 7 of “On the remote
control” (page 20) in “Labeling
recordings”, and then keep pressing the
x for 2 seconds or more.
To cancel labeling
Press CANCEL on the recorder.
Press DISPLAY for 2 seconds or more on the
remote control.
Notes
• Track and disc titles that were entered in
English katakana characters will appear in
Roman letters on minidisc players that do not
support the display of katakana characters.
Such titles will be marked with a “^” at the
beginning and the end.
• You cannot relabel premastered MDs or label
MDs that have not been recorded.
• The recorder cannot rewrite a track, group, or
disc name of more than 200 letters that was
created by another device.
Storing phrases
frequently used in
labeling (Name Bank
Function)
See the illustrations in English text (page 50).
Phrases that you often use while labeling can be
stored in the recorder’s memory.
Approximately 25 phrases of about 10
characters each (with a total character count of
about 400) can be stored in the phrase bank.
The actual number will depend on the length of
each phrases.
Storing phrases while labeling
a track or disc
You can store phrases in three ways.
• Storing phrases while labeling a
track, group, or disc:
You can store phrases while labeling a
track, group, or disc by doing the
procedure “Labeling recordings”
(page 19).
• Storing phrases from a previously
labeled track, group, or disc:
You can store an existing track, group, or
disc name as a phrase.
• Inputting and storing phrases:
You can store frequently used phrases in
advance, and then retrieve and use them
when labeling a track, group, or disc.
Storing phrases while labeling a
track or disc
On the recorder
1 Follow steps 1 to 7 of “Labeling
recordings” (page 19) to enter a phrase.
continued