Filter
Top Products
11
4 Turn the jog dial repeatedly until “From
End” flashes in the display, and then
press to enter.
To start recording from the current point
Select “From Here” in step
4.
Notes
• The setting will remain even after the power is
turned off.
• If you start recording while the recorder is in
play-paused, the recording will begin from the
point at which it is paused even when the
“REC-Posi” is set to “From End”.
Recording from a
microphone
See the illustration in English text (page 29).
1 Connect a stereo microphone (ECM-
717, ECM-MS907, ECM-MS957, etc.,
not supplied) to the MIC (PLUG IN
POWER) jack.
2 Press and slide REC to the right.
To select microphone sensitivity
1 Press the jog dial while the recorder is
stopped.
2 Turn the dial repeatedly until “MIC
SENS” flashes in the display, and then
press to enter.
3 Turn the jog dial repeatedly to select
“SENS HIGH” (when recording a soft
sound or a sound in the distance) or
“SENS LOW”(when recording a loud
sound or a sound at close range), and
then press to enter.
Notes
• The recorder automatically switches input in
the following order; optical input, microphone
input, and analog input. You cannot record
through the microphone while an optical cable
is connected to the LINE IN (OPT) jack.
• The microphone may pick up the operating
sound of the recorder itself. Use the
microphone away from the recorder in such
cases. Please note that the sound of recorder
operations may be picked up if the
microphone that you use has a short
connector.
• Only the left-channel sound is recorded when
a monaural microphone is used.
Adding track marks
automatically at
specified intervals (Auto
Time Stamp)
See the illustration in English text (page 30).
Use this feature to add track marks
automatically at specified intervals when
recording through the analog input connector or
a microphone.
1 While the recorder is recording or in
recording pause, press the jog dial.
2 Turn the jog dial repeatedly until
“TIME MARK” flashes in the display,
and then press to enter.
3 Turn the jog dial repeatedly until the
desired time interval flashes in the
display, and then press to enter.
Select one of the following intervals:
“OFF”
“5 min. ON” (track marks are added in
every 5 minutes.)
“10 min. ON” (track marks are added in
every 10 minutes)
“15 min. ON” (track marks are added in
every 15 minutes)
To cancel the setting, select “OFF” in
this step.
Notes
• Automatic track marking by Auto Time Stamp
starts when you add a normal track mark to
the disc (i.e., by pressing T MARK or X,
etc.).
• The setting will be lost when the recording
stopped.