Filter
Top Products
18
Connecting to a stereo
system (LINE OUT)
See the illustration in English text 45.
Connect the i/LINE OUT jack of the recorder
to the LINE IN jacks of an amplifier or a tape
recorder with a line cable (RK-G129 or RK-
G136, not supplied).
The output is analog. The recorder plays the
MD digitally and sends analog signals to the
connected equipment.
When connecting a line cable to
the
i/LINE OUT jack
When connecting a line cable (not supplied), be
sure to set the “AUDIO OUT” parameter for the
i/LINE OUT jack.
1 Press the jog dial.
2 Turn the dial until “AUDIO OUT”
flashes in the display, and then press to
enter.
3 Turn the dial until “LINE OUT” flashes
in the display, and then press to enter.
Notes
• If the “AUDIO OUT” parameter for the i/
LINE OUT jack is set to “LINE OUT”,
VOLUME +/– or Digital Sound Preset will
not function.
• The “AUDIO OUT” parameter for the i/
LINE OUT jack cannot be set to “LINE OUT”
when the supplied remote control is
connected.
• When you connect the headphones/earphones
directly to the recorder, set the “AUDIO
OUT” parameter for the i/LINE OUT jack to
“HeadPhone”.
B Editing recorded tracks
You can edit your recordings by adding/erasing
track marks or labeling tracks and discs.
Premastered MDs cannot be edited.
Notes on editing
• You cannot edit tracks on an MD that is record
-protected. Before editing tracks, close the tab
on the side of the MD.
• If you perform an editing operation while
playing, editing results will not be recorded
until you stop the recorder and “TOC Edit”
disappears in the display.
• Do not move or jog the recorder while “TOC
Edit”* is flashing in the display.
• The lid does not open until “TOC Edit”
disappears in the display after editing.
• When the group mode is on, editing can be
performed only for the tracks registered into
the selected group.
* TOC = Table of Contents
Labeling/relabeling
recordings
See the illustrations in English text (pages 46 to
49).
You can name tracks, groups and discs using
the recorder’s character palette.
Available characters
• Capital and small letters of the English
alphabet.
• Numbers 0 to 9
• ! " # $ % & ( ) * . ; < = > ? @ _ `
+ – ' , / : _(space)
Numbers of characters you can
input
Track, group, or disc name: Approx. 200 each
(all available characters are mixed).
Numbers of characters you can
input in a disc
Alphanumeric characters/symbols only
Approx. 120 titles of about 10 characters each
(a maximum of about 1,700 letters)
The number of titles that can be stored on a disc
depends on the number of characters that are
input for track names, group names, and disc
name.