Filter
Top Products
23
GB
Recording on an MD
Recording an MD
You can record on an MD from a variety of program
sources (including CD). Make sure the program source is
connected correctly before you begin. See page 5 for
details on connections.
1 Turn on the program source you want to record.
2 Press U to turn on this unit.
The display lights up.
3 Insert a recordable MD.
4 Set INPUT to the program source you want to
record.
If program source is connected to Set INPUT to
DIGITAL OPTICAL IN OPT
DIGITAL COAXIAL IN COAX
LINE (ANALOG) IN ANLG
5 Press r REC.
The unit enters record pause mode and the indicator
next to REC PAUSE starts blinking (recording has not
yet begun).
(continued)
z You can mark track numbers manually at any time during or
after recording.
For details, see “Marking Track Numbers While Recording” on
page 24 and “Dividing a Track” on page 28.
When “TOC Writing” blinks in the display
The unit is storing the contents of the recording on the
MD. Do not turn off the power (U), pull out the AC
power cord, or move the unit. This may prevent correct
recording. Turning off the power (U) or pulling out the
AC power cord immediately after recording will prevent
the unit from storing the recording.
This unit complies with the Serial Copy
Management System
MDs recorded digitally cannot be further copied to other
digital media (MD, DAT, etc.) through this unit’s digital
output jacks (see page 41).
INPUT
r REC
STOP
PLAY/PAUSE
REC VOL
U (power)
REC PAUSE
Insert in direction of arrow
Label facing up