Filter
Top Products
For the surround amplifier
For the S-AIR receiver
It is easy to set tile same 1D for the unit and an
S-AIR sub unit, such as a surround amplifier or
S-AIR receiver, to establish sound transmission.
However, neighbors may also receive your
system's sound if 1Ds are tile same, or you may
receive the sound li"om neighbors. To prevent
this, you can ideudl_ the unit with a specific
S-AIR sub unit by performing the pairing
operation.
When you perform pairing
Before pairing, sound mmsmission is
established by tile 1D (example).
Your room Neighbor
This unit
S-AIR sub unit
b
S-AIRsub unit
After pairing, sound transmission isestablished
between tllepaired unit and S-AIR subunit(s)
only.
Your room
This unit
y,,,,,_
L
S-AIR sub unit
Neighbor
I
I Notransmission
$
S-AIRsub unit
2
Pairing
Place the S-AIR sub unit that you want
to pair near the unit.
•Remove headphones from the sin-round
amplifier (if connected).
Match the IDs of the unit and the S-AIR
sub unit.
• To set the ID of the unit, see "To set tile 1D
of tile unit" (page 83).
• To set tile 1D of the surround amplifier,
see "To set the ID of tile surround
amplifier" (page 84).
• To set the ID of the S-AIR receiver, refi2r
to the operating instructions of the S-AIR
receiver.
3 Press FUNCTION +/- repeatedly until
"DVD" appears in the front panel
display.
4 Press @ DISPLAY while the system is
in stop mode.
The Control Menu display appears on tile
TV screen.
5 Press €,14,to select B [SETUP],
then press @.
The options for [SETUP] appear.
6 Press €,14,to select [CUSTOM], then
press @.
The Setup Display appears.
7 Press €,14,to select [AUDIO SETUP],
then press @.
The options for [AUDIO SETUP] appear.
86us