Filter
Top Products
Symptom Remedy
No sound or only a very low= • Check the speaker connections and settings (pages 25, 73).
level sound is heard from the • Make sure the "DEC. MODE" setting (page 49).
surround speakers. . Depending on Ihe source, the effect of Ihe surround speakers may be less
noticeable.
• Check the wireless setting (page 42).
• A 2 channel source is being played.
There is no sound from the • The sampling frequency of the input signal is more than 48 kHz.
DIGITAL IN COAXIAL/
OPTICAL jack.
Operation
Symptom Remedy
Radio stations cannot bc tuned • Check that the antenna (aerial) is connected securely. A_!just the antenna
in. laerial) or connect an external antenna (aerial) if necessary.
• The signal strength of the stations is too weak (when tuning in with automatic
tuning) Use direct tuning
• No stations have been preset or the preset stations have been cleared (when
tuning by scanning preset stations) Preset the stations (page 76)
• Press DISPLAY so that the frequency appears in the front panel display
• Check the location of the AM loop antenna (aerial) and cord (page 35)
• There are obstacles between the remote and the unit
• The distance between the remote and the unit is too far
• The remote is not pointed at the remote sensor on the unit
• The batteries in the remote arc weak
• There is no disc inserted
• The disc is upside down
Insert the disc with the playback side facing down
• The disc is skewed on the disc tray
• The system cannot play CD-ROMs, etc (page 6)
• The region code on the DVD does not match the system
• Moisture has condensed inside the unit and may cause damage to the lenses
Remove the disc and leave the unit turned on for about half an hour
• The DATA CD is not recorded in the MP3 lk)rmat that conlk)rms to ISO 9660
Level l_evel 2, or Joliet
• The DATA DVD is not recorded in an MP3 lk)rmat that conlk)rms to UDF
(Universal Disk Format)
• The MP3 file does not have the extension "MP3"
• The data is not formatted in MP3 even though it has the extension "MP37
• The data is not MPEG 1 Audio Layer 3 data
• The system cannot play audio tracks in MP3PRO format
• The [MODE (MUSIC. IMAGE)] setting has been set to [IMAGE[ (page 64)
• If you cannot change the [MODE (MUSIC. IMAGE)] setting, reqoad the disc
or turn the system off, then on
Noise is heard on AM radio
The remote does not flmction
The disc does not play
The MP3 file cannot be played
102Us