Filter
Top Products
Sound
Symptom
There is no sound.
No sound isoutputfromthe
HDMI OUTjack
The left and right sounds arc
unbahmced or reversed
There is no sound from the
subwool_.r
Severe Imm or noise is heard
Remedy
•The speaker cord is not connected securely.
• Press MUTING on theremote if"MUTING ON" is displayed in the front panel
display
• The system is inpause mode or in Slow-motion Play mode Press [2:>to return
to normal play mode.
• Fast forward or fast reverse is perlbrmed Press [2:>to return to normal play
mode.
• Check the speaker settings (page 73).
• Super Audio CD audio signals are not output from the HDMI OUT jack.
• The component connected to the HDMI OUTjack does not conform tothe
audio signal format, inthis case set ]AUDIO (HDMI)] in [HDMI SETUP] to
[ON] (page 71)
• Set [AUDIO (HDMI)] in [HDMI SETUP] to [ON] (page 71).
• The HDMI OUT jack isconnected to i DVI (Digital Visual Interface) device
(DVI (Digital Visual Interface)jacks do not accept audio signals)
• The HDMI OUT jack does not output Super Audio CD sound
• Try the following: (_) Turn the system off and on again @ Turn theconnected
component off and on again. (_) Disconnect and then connect the HDMI cable
again
• Check that the speakers and components are comlected correctly and securely
• Check the speaker connections and settings (pages 25 73)
• Select "AFD STD" lot DEC MODE" (page 49)
• Check that the speakers and components are connected securely
• Check that the connecting cords arc away from a translbrmer or motor, and at
least 3 meters ( 10 fl) away from your TV set or a fluorescent light.
• Move your TV away from the audio components
• The plugs and jacks are dirty Wipe them with a cloth slightly moistened with
alcohol.
• Clean the disc
The sound loses stereo elli:ct • Set ]AUDIO] to ]STEREO] by pressing AUDIO (page 54)
when you play a VIDEO CD, a • Make sure the unit is connected properly.
CD, or an MP3 file.
The surround eflk.ct is difficult to • Make sure the "DEC MODE" setting (page 49).
hear when you are playing a • Check the speaker connections and settings (pages 25, 73)
sound track (51:Dolby Digilal, • Depending on the DVD, the oulput signal mty not be the enlire 5.1 channeh II
DTS, or MPEG audio, may be monaural (51stereo even if Ihe sound Irack is recorded in Dolby Digilal
or MPEG audio format.
The sound comes from the center • Depending on the disc, the sound may come from the center speaker only.
speaker only.
No sound is heard from the • Check the speaker connections and settings (pages 25, 73).
center speaker. • Make sure Ihe "DEC. MODE" setting (page 49).
• Depending on the source, the elli:ct of the center speaker may be less
noticeable.
• A 2 channel source is being played.
5"
8"
o
1(11Us