Filter
Top Products
Sound Iransmission is established as with a specific S-AIR sub unil by performing tile
follows (example): pairing operation (page 86).
OtherS-AIR main
This unit unit
S-AIR sub unit S-AIR sub unit S-AIR sub unit
• To confirn/the current ID, perform Steps 1to 7
above. When you pair the unit with the S-AIR sub
unit (page 86), [(PAIRING)] appears beside ID on
the display lbr selecting ID.
To set the ID of the surround
amplifier
1 Make sure that the SURROUND
SELECTOR switch of the surround
amplifier is set to SURROUND.
Set the S-AIR ID switch of the surround
amplifier to match the ID (A, B, or C) of
the unit.
3 Press POWER on the surround
amplifier.
When sound transmission is established,
the POWER / ON LINE indicator of the
surround amplifier turns green.
For details of the POWER / ON LINE
indicator, see "To check the transmission
status" (page 42).
To set the ID of the S-AIR
receiver
Reli:r to the operating irrstructions of the S-AIR
receiver.
m
• It is easy to set the same IDlbr theunit and S-AIR sub
unit to establish sound transmission. However,
neighbors may also receive your system's sound if
lDs are the same, or you may receive the sound from
neighbors. To prevent this, you can identify the unit
For the S-AIR receiver
You can enjoy the system's sound by using tire
S-AIR receiver. The S-AIR receiver can be
installed anywhere, regardless of the location of
the unit, lot enjoying the system's sound in
arrother roou].
For details of the S-AIR receiver, refer to the
operaling irrstructions of the S-AIR receiver.
1 Set the ID of the S-AIR receiver to that
of the unit.
• To set the ID of the unit. see "To set the ID
of the unit" (page 83).
• To set the ID of the S-AIR receiver, refi:r
to the operating instructions of the S-AIR
receiver.
2
• When you are using another S-AIR sub unit,
such as a surround amplifier, do not chmge the
ID of the unit. Set the ID of the S-AIR receiver
to the same ID asthe unit.
• When you pair the unit and another S-AIR sub
unit, such as asurround amplifier, by the pairing
operation, you need to perR)rm the pairing
operation between the unit and the S-AIR
receiver. For details, see "Identil}ing the unit
with a specific S-AIR sub unit (Pairing
operafion)" (page 86).
Press S-AIR MODE on the remote.
Tire S-AIR mode appears in the front panel
display. Each time you press S-AIR
MODE. tire S-AIR mode changes.
• "PARTY": The S-AIR receiver outputs
sound according to function set on the
unit.
• "SEPARATE": You can set the desired
flmction for the S-AIR receiver while unit
flmctions do not change.
84us