Filter
Top Products
Page 62 of 78
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airClient™ Nexus PRO TOTAL User Guide
8.1.1 SNMP Security
The user can edit the SNMP Community String and SNMP Access filters. The SNMP community needs to
match with the SNMP monitoring software used. The SNMP Access Filters allows you to determine which
host(s) is authorized to monitor the device using SNMP. It is recommended that you set this for security
reason and to prevent an attack. To change the SNMP security settings, click on the SNMP security link
in the System Configuration page. Figure 7-2 shows the SNMP Security Configuration page.
Follow the steps below to change the SNMP security settings.
1. Enter New Community and Confirm Community with the same string.
2. Check the ‘SNMP Access Filters’ Enable box.
3. Enter Access Filters IP Address and Mask. Up to three IP’s settings can be entered.
4. Click the ’Apply Changes’ button.
Figure 8-2 SNMP Security Configuration
Table 8-2 Description of SNMP Page Items
Page Items Descriptions
SNMP Community
Display SNMP Community String that is currently used to communicate to the
device through SNMP
New Community
User can change the SNMP Community String by entering a new Community
string
Confirm
Community
User must enter the same community string as a new community string to
confirm.
Access Filters
Display the Current Access Filter status
User can change the Access Filter status.
IP
List of 3 IP filters.
User can enter the IP address and mask.