Filter
Top Products
Page 21 of 78
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airClient™ Nexus PRO TOTAL User Guide
2.7. aCNPT Bridge Configuration
The aCNPT in Bridge mode can associate only with a smartBridges airPoint access point in bridge mode
(SB3210) as they both use WDS link implementation. It can associate with any third party bridge but the
link is more effective with a smartBridges airPoint.
The following sections outline the procedures for changing the settings for bridge mode.
2.7.1. Ethernet Configuration
The Ethernet IP is configured when the operational mode was changed to the bridge mode.
Follow these steps below if you need to re-configure the aCNPT Bridge Ethernet parameters:
1. From the ’Summary Information’ page, click on the ’Ethernet Configuration’ link.
2. Select DHCP enable/disable radio button. Enter the ‘IP address’, ‘IP mask’, ‘Gateway’ for non
DHCP. Assign the unit a unique IP Address in the designated IP subnet.
3. Click on the ‘Apply Changes’ button to effect the changes.
Figure 2-9 aCNPT Bridge Ethernet Configuration