Sherwood R-771 Stereo Receiver User Manual


 
ENGLISH
Relationship between the video input signal and the video output signal
*
1
: Component video signal can be output from the MONITOR COMPONENT OUT jacks only.
*
2
: The video signal set in the VIDEO MODE menu can be output from all the types of MONITOR OUT jacks.
*
3
: The OSD menu and the momentary OSD cannot be displayed via MONITOR COMPOSITE OUT jack.
*
4
: If the OSD menu operation is performed, the picture is automatically turned off and only the OSD menu is
displayed via MONITOR COMPONENT OUT jacks.
Note :
• When outputting the component video signal from the MONITOR COMPONENT OUT jacks as it was input, the momentary
OSD cannot be displayed.
Video input signals MONITOR OUTs
COMPONENT S-VIDEO (COMPOSITE) VIDEO COMPONENT S-VIDEO (COMPOSITE) VIDEO
Auto Component S-Video Composite video*
3
Component*
1
Component*
4
S-Video*
2
S-Video S-Video S-Video
Composite*
2
Composite video Composite video Composite video
Auto Component S-Video S-Video
Auto Component Composite video Composite video
Auto Component*
4
Auto S-Video S-Video Composite video*
3
Auto S-Video S-Video S-Video
Auto Composite video Composite video Composite video
7
Video Mode
Setting
• There are three types of video jacks(COMPONENT, S-VIDEO, (composite) VIDEO) for connecting video
components.
Connect them to the corresponding video jacks according to their capability.
• For your reference, the excellence in picture quality is as follows : "COMPONENT” > "S-VIDEO” >
"(composite) VIDEO”.
• When making COMPONENT VIDEO connections, connect "Y" to "Y", "P
B/CB" to "CB"(or "B-Y", "PB") and
"PR/CR" to "CR"(or "R-Y", "PR" ).
• When recording video program sources through VIDEO 1 OUT jacks or viewing ROOM 2 source through
ROOM 2 OUT jack, you must use the same type of video jacks that you did connect to video playback
components such as DVD player, LD player, etc.
• This unit is equipped with a function that up-converts composite video or S-Video signals to component video
signals or down-converts S-Video signals to composite video signals and outputs them from the MONITOR
OUTs. Because of this, you need not connect all the types of MONITOR OUT jacks to the MONITOR TV.
• After connecting the video components, you should set the video mode correctly, referring to the following
table.
(For details, refer to "When selecting the VIDEO MODE" on page 41.)
Continued