Filter
Top Products
ENGLISH
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL
ROOM EQ
auto setup
17
LOADING BATTERIES
REMOTE CONTROL OPERATION RANGE
1 2
• Use the remote control unit within a range of
about 7 meters (23 feet) and angles of up to
30 degrees aiming at the remote sensor.
OPERATING COMPONENTS WITH REMOTE CONTROL
• Remove the batteries when they are not used
for a long time.
• Do not use the rechargeable batteries(Ni-Cd
type).
• Be sure to use alkaline batteries.
Remove the cover.
Load two batteries("AAA" size)
matching the polarity.
1
Enter the setup code for each
component other than this receiver.
For details, refer to "Entering a setup
code" on page 18.
2
Turn on the component you want to
operate.
3
Press the DEVICE button on the
remote control corresponding to the
component you wish to operate.
4
Aim the remote control at the REMOTE
SENSOR of the component you wish
to control and press the button
corresponding to the operation you
want.
• When operating a Sherwood CD player or tape
deck using digi link system remote control, aim
the remote control at the REMOTE SENSOR of
this receiver.
However, to operate a Sherwood DVD player,
aim at the REMOTE SENSOR of the
corresponding component.
• When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within several
minutes after removing old batteries.
• If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared. Should
this happen, you should memorize them again.