Filter
Top Products
ENGLISH
27
Adjusting the current channel level
Press the CHANNEL LEVEL button.
1
• Each time these button are pressed, the
corresponding channel is selected as follows:
REF 1 (or CAL) FL C FR SR
<DTS L or DD L>
SW SL( SB) or( BL BR)
DTS LFE Dolby Digital LFE
( ): Possible depending on whether the surround back channel is
set to "2 CH" or "1 CH".
< >: Possible only when the digital signals from Dolby Digital or
DTS program sources that include LFE signal are input.
• Depending on the speaker settings("NONE", etc.) and surround mode, etc., some channels cannot be
selected.
• When the SPEAKER button is set to off, only the Front Left and Front Right channels can be selected.
• After adjusting each channel level with test tone, adjust the channel levels either according to the
program sources or to suit your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into
user’s memory ("CAL"), not into preset memory("REF 1", "REF 2").
Select the desired channel.
2
• The LFE level can be adjusted within the range of
-10~0 dB and other channel levels within the
range of -15~+15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended
LFE level for some early DTS software is -10 dB.)
If the recommended levels seem too high, lower
the setting as necessary.
Repeat the above steps and to adjust each channel level.
4
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL
CONTROL
• Then the memory mode ("CAL" or "REF 1") is
displayed for several seconds.
• When the memory mode or channel level
disappears, press this button again.
Adjust the level of the selected channel as desired.
3
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL