Filter
Top Products
ENGLISH
11
9. CONNECTING DC TRIGGER OUT
• Connect a component to DC TRIGGER OUT jack that
allows DC 12 V to turn on when a specific input source
is selected.
• For details, refer to the operating instructions of the
components to be connected .
• To link DC TRIGGER OUT with a specific input source,
refer to "When selecting the DC TRIGGER" on page 41.
Notes :
• This output voltage (12 V d.c., 100mA ) is for (status)
control only, it is not sufficient for drive capability.
• When making DC TRIGGER connection, you should
use the stereo mini cord, not a mono mini cord.
10. CONNECTING ROOM 2 OUTs
• ROOM 2 playback feature allows you to play a different program source in another room as well as one source in the main
room at the same time.
• For ROOM 2 playback, connect the ROOM 2 OUT jacks to the amplifier, TV, etc. installed in another room, or connect the
SURROUND BACK/ROOM 2 speaker terminals to the speakers.
• When connecting the ROOM 2 /TAPE OUT jacks, you should assign the output to the ROOM 2.
(For details, refer to "When selecting the OUT ASSIGN" on page 37.)
• When connecting the SURROUND BACK/ROOM 2 speaker terminals, you should assign the power amplifier for surround
back/room 2 channels to the ROOM 2. (For details, refer to "When selecting the AMP ASSIGN" on page 37.)
Notes :
• To minimize hum or noise, use high quality connection cords.
• You cannot use the digital audio signal for ROOM 2 playback.