Filter
Top Products
ENGLISH
50
SETTING THE CH LEVEL SETUP
Note :
• Depending on the speaker settings("NONE", etc.), some channels cannot be selected.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into
user’s memory("CALIBRATE"), not into preset memory("REF 1", "REF 2")
• After adjusting each channel level with test tone, adjust the channel levels either according to the
program sources or to suit your tastes.(For details, refer to "Adjusting each channel level with test tone"
on page 26.)
• The LFE level can be adjusted within the range of
-10 ~ 0 dB and other channel levels within the
range of -15 ~ +15 dB
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower setting
as necessary.
Adjusting the current channel level
Press the CURSOR UP( )/DOWN( ) buttons to select the desired channel.
1
Press the CURSOR LEFT( )/RIGHT( ) buttons to adjust the level of the selected channel or
program source's LFE as desired.
2
Repeat the above steps and to adjust each channel level.
3
When adjusting the LFE LEVEL
1. Press the CURSOR UP(
)/DOWN( )buttons to select the LFE LEVEL SETUP, then press the ENTER
button.
2. Press the CURSOR UP(
)/DOWN( ) buttons to select the desired program source.
Memory mode
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL