Filter
Top Products
ENGLISH
21
LISTENING TO A PROGRAM SOURCE
Operations
Before operation
Select the desired input source.
3
• Enter the standby mode.
• The POWER ON/STANDBY button
lights up in amber. This means that
the receiver is not disconnected from
the AC mains and a small amount of
current is retained to support the
operation readiness.
• To switch the power off, push the
POWER switch again.
• Then the power is cut off and the POWER ON /
STANDBY button goes off.
• Then the SPEAKER indicator lights up
and the sound can be heard from the
speakers connected to the speaker
terminals.
• When using the headphone for private
listening, press the SPEAKER button again to
switch the speakers off.
• Each time the "AUDIO" button on the front panel
is pressed, the input source changes as follows;
TUNER CD AUX TAPE
(frequency display)
• Each time the "VIDEO" button on the front panel
is pressed, the input source changes as follows;
VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4
When selecting the EXTERNAL IN as desired,
• Depending on the power amplifier setting for the
surround back channels and the surround back
speaker setting, "EXT IN" is displayed and 8(/7/6)
separate analog signals from the component
connected to this input pass through the tone and
volume circuits only and can be heard from your
speakers.
• Press the EXTERNAL IN button or select the
desired input source to cancel the external in
function.
• These analog signals can be heard only, not
recorded.
Switch the speakers on.
2
ENTER
ENTER
CH.LEVEL
CH.LEVEL
CHANNEL
CHANNEL
ENTER
ENTER
CH.LEVEL
CH.LEVEL
CHANNEL
CHANNEL
Notes:
• Before operating this receiver with the supplied remote control, refer to "Universal Remote Controls" on page 15
for details about operation.
• Before operating this receiver, first set this unit as desired for optimum performance, doing the OSD menu
setting procedures. (For details, refer to "OSD Menu Settings" on page 35.)
In the standby mode, turn the power
on.
1
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL
• Each time the POWER ON/STANDBY button on
the front panel is pressed, the receiver is turned on
to enter the operating mode (the POWER ON/
STANDBY button lights up in blue) or off to enter
the standby mode(the POWER ON/STANDBY
button lights up in amber).
• On the remote control, press the POWER ON
button to enter the operating mode or press the
STANDBY button to enter the standby mode.
• In the standby mode, if the INPUT SELECTOR
button is pressed, the receiver is turned on
automatically and the desired input is selected.