Filter
Top Products
ENGLISH
Cancel the test tone function.
3
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL
ENTER
ENTER
CH.LEVEL
CH.LEVEL
CHANNEL
CHANNEL
At each channel, adjust the level as
desired until the sound level of each
speaker is heard to be equally loud.
2
To cancel the surround mode for stereo operation
• Depending on the signal format which is being input, either the stereo
mode or the 2CH downmix mode is selected.
• To cancel either the stereo mode or the 2CH downmix mode, select
the surround mode with using the MULTI CONTROL knob on the
front panel or the SURROUND MODE UP/DOWN ( >/< ) buttons on
the remote control.
2CH downmix mode
• This mode allows the multi-channel signals encoded in DTS or Dolby Digital format to be mixed down into 2 front
channels and to be reproduced through only two front speakers or through headphones.
• When the SPEAKER button is set to off to listen with headphones, if the STEREO button is pressed while playing
the multi-channel digital signals from DTS or Dolby Digital sources, it will enter the 2CH downmix mode
automatically.
• To cancel the 2CH downmix mode, select the desired Dolby Headphone mode with using the MULTI CONTROL
knob on the front panel or the SURROUND MODE UP/DOWN ( >/< ) buttons on the remote control.
26
• The Dolby Headphone function simulates 5.1 channel surround sound, which allows you to enjoy 5.1 channel
surround sound through 2 channel headphones, just like listening from 5.1 channel speakers.
Notes :
• Only when the SPEAKER button is set to off, the Dolby Headphone mode can be selected.
• When playing the 96 kHz PCM(2 channel) digital signals, only the stereo mode can be selected.
• While listening with headphones, select the desired Dolby Headphone mode.
• Each time the MULTI CONTROL knob is rotated or the SURROUND
MODE UP/DOWN ( >/< ) buttons are pressed, the mode changes as
follows :
DH 1 : This simulates the soundfield as if you were in a relatively small room
with less reverberations.
DH 2 : This simulates the soundfield as if you were in a typical listening room
with moderate reverberations.
DH 3 : This simulates the soundfield as if you were in a large space like theater.
Listening in a Dolby Headphone mode
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL
Continued
Enter the test tone mode.
1
• The volume level of each channel can be adjusted easily with the test tone function.
Note : When the SPEAKER button is set to off or it is in the stereo mode, the test tone function does not
work.
Adjusting each channel level with test tone
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows:
FL
C FR SR
Front Left Center Front Right Surround Right
SW SL ( SB) or ( BL BR)
Subwoofer Surround Left Surround Back Surr.Back Left Surr.Back Right
• When the speaker setting is "NONE", the test tone of
the corresponding channel is not available.
• ( ) : Possible depending on whether the surround
back channel is set to "2 CH" or "1 CH".
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL