Filter
Top Products
ENGLISH
48
Repeat the above steps and until the crossover frequencies are all set as desired.
4
• You can adjust the crossover frequency within
the range of 40 ~ 200 Hz in 10 Hz intervals.
Press the CURSOR LEFT( )/RIGHT( ) buttons to set the crossover frequency as desired.
3
Press the CURSOR UP( )/DOWN( ) buttons to select the SPEAKER X-OVER, then press
the ENTER button.
1
When selecting the SPEAKER X-OVER
Press the CURSOR UP( )/DOWN( ) buttons to select the desired speaker.
2
Note :
• You cannot select the subwoofer and the speakers
set to "NONE".
About the crossover frequency
• When speakers are set to "SMALL", low frequencies in those channels that are below the crossover
frequency are to output from subwoofer or front speakers which are set to LARGE(when not using a
subwoofer).
• Refer to the operating instructions of the speakers to be connected. If the frequency range of your speaker
is 100 Hz~20 kHz, the crossover frequency should be set to 100 Hz(or slightly higher).
• When speakers are set to "SMALL", be sure to set their crossover frequency correctly according to
their frequency characteristics.
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL